Tourist mines
Tourist mines have specific obligations under the WHS (Mines) laws
Regulation of tourist mines
If a mine is classed as a tourist mine under the WHS (Mines and Petroleum Sites) laws, then it is regulated by the Resources Regulator.
If the tourism operation is not considered a mine or a tourist mine for the purposes of the WHS (Mines and Petroleum Sites) laws, then only the Work Health and Safety Act 2011 and associated Regulation will apply and the operation will be under the jurisdiction of SafeWork NSW.
What are tourist mines?
A tourist mine, as defined in the WHS (MPS) Act, is a mine at which:
-
no mining operations are carried out other than those associated with educational, or tourism pursuits carried out in connection with former mining activities at the mine
-
there is a principal hazard that was also present at the mine when former mining activities were carried out.
The WHS (Mines and Petroleum Sites) laws do not apply to an activity carried out in relation to fossicking or the extraction of minerals on private land for the private and non-commercial use of the owner of the land.
What are prescribed hazards?
The prescribed hazards are the same as principal hazards. They include any activity, process, procedure, plant, structure, substance, situation or other circumstance relating to the carrying out of mining operations that has a reasonable potential to result in multiple deaths in a single incident or a series of recurring incidents.
The hazards can include:
- ground or strata failure
- inundation or inrush of any substance
- mine shafts and winding systems
- roads or other vehicle operating areas
- air quality or dust or other airborne contaminants
- fire or explosion
- gas outbursts
- spontaneous combustion
- subsidence
- any other hazard identified by the mine operator.
There must be a reasonable potential that the hazard could, if not appropriately managed, result in multiple deaths in a single incident or a series of recurring incidents. The fact there could be a hazard listed above is not sufficient for it to meet the definition of a prescribed hazard for a tourist mine. The hazard must be accompanied by the reasonable potential it could result in multiple fatalities.
Permits
Permits are not required to operate a tourist mine. However, the mine operator must give the regulator notice 1 month before the proposed commencement of a tourist mine.
Does a mine become a tourist mine if it starts offering tours?
No. Any mines where minerals are being extracted or other mining operations are occurring is considered a mine (rather than a tourist mine), even if tourist or educational activities such as site tours are also conducted. Such tourist or educational activities are to be managed together with the other mining operations occurring at the mine.
What are the obligations of operators of tourist mines?
In addition to provisions under the WHS legislation, all relevant provisions of the WHS (Mines and Petroleum Sites) Regulation apply except where specifically excluded for tourist mines. Key requirements include:
- notifying the Regulator about the mine operator (section 6)
- notifying the Regulator of the proposed commencement or other specified event, such as suspension or closure, of the tourist mine (section 125)
- managing risks to health and safety associated with mining operations (section 14-17)
- developing, implementing, maintaining and reviewing a safety management system (section 18-22)
- providing information to adjoining mine owners (section 23)
- emergency planning (section 91-105)
- obligations in relation to contractors (section 24)
- information, training and instruction for workers and visitors (section106-111)
- notifying the Regulator of certain incidents (including notifiable incidents and high potential incidents section 124-125)
- keeping a mine record (section 129-130).
The safety management system for a tourist mine
The safety management system must provide a comprehensive and integrated system for the management of all aspects of risks to health and safety relating to the mine's operation. This includes:
- the nature, complexity and location of the mining operations, and
- the risks associated with those operations.
Operators of tourist mines are not required to prepare principal mining hazard management plans and principal control plans. Instead, they must ensure that the safety management system for the mine sets out the systems, procedures, plans and other control measures that will be used to control any risks to health and safety at the mine associated with the following:
- Ground or strata failure
- Inundation or inrush of any substance
- Mine shafts and winding systems
- Roads or other vehicle operating areas
- Air quality or dust or other airborne contaminants
- The mechanical aspects of plant or structures
- Electricity
- Ventilation
- A hazard identified by the mine operator that has a reasonable potential to result in multiple deaths in a single incident or a series of recurring incidents.
Related links
You might also be interested in
- Guidance on WHS (MPS) laws
- Guide - Understanding the term 'mining operations' (PDF, 532.5 KB)
- Contractors and other businesses at mines and petroleum sites guide (PDF, 169.82 KB)